Thanks: 0
Likes: 19
Hybrid View
-
09-08-2012, 08:05 AM #1
Finding the inside beginning of a skein
Is there a trick or sure-fire way of finding the beginning of the skein so I can work from the inside out instead of outside in? When I buy yarn I usually look for the end sticking out, but sometimes I forget. I have to keep pulling yarn until the skein gets small enough to unwind on its own.
See what Joyce Writes on Yahoo
-
09-08-2012, 09:45 AM #2
-
09-08-2012, 09:52 AM #3
If there is a method, I sure haven't discovered it. So, much like my grandma who taught me to crochet and knit, I roll it into a ball by hand starting from the outside thread of the skein. It sounds like tedious work, but done in front of the television, it keeps my hands busy in a way that uses rather than adds calories! 😉
-
Post Thanks / Like - 0 Thanks, 2 Likescharlene corbin, Ramona49 liked this post
-
09-08-2012, 09:59 AM #4
Here is another short article on "How to start a skein" from Lion Brand:
Tips and Techniques : How do I start a skein? : Frequently-Asked Questions (FAQ) about Knitting and Crochet : Lion Brand Yarn
-
Post Thanks / Like - 0 Thanks, 3 Likes
-
09-08-2012, 09:56 AM #5
:-) Thanks... that's what I have done on occasion... usually though when it gets down to about half a skein left.
-
09-08-2012, 09:58 AM #6
Hello,
Here is some info from Lion Brand which is useful:
About Yarn : How do I find the end of the skein or ball? How do I pull from the center? : Frequently-Asked Questions (FAQ) about Knitting and Crochet : Lion Brand Yarn
-
Post Thanks / Like - 0 Thanks, 5 Likes
-
09-08-2012, 11:18 AM #7
Hey, Yawl,
Does it make a difference on working from the inside out or the outside in? I just wad up some paper and unravel the yarn that way into a ball. I do it in front of the TV too.
I thought the yarn was consistent through out. Maybe it is personal preference.
Happy Crafting,
Landon
-
09-08-2012, 02:51 PM #8
It doesn't matter in the sense that your crocheted item will look the same hooked either way. For me, the two ways each have their positive and negative aspects.
Use yarn from center pull:
PRO. Yarn does not tend to roll around as much since it unwinds within the center of the skein. Perhaps the yarn stays cleaner since the exposed yarn is limited to the outer layers. If it works, it saves time since no rolling into a ball isrequired before stitching. Yarn stacks easier since balls just can't be piled up upon one another.
CON: In my experience the yarn frequently becomes tangled. Then, you have huge knot between your yarn and your work and this positioning can make it very difficult to untangle.
Use From Outside:
PROS: The chance of a tangle is minimal. Balling is not really necessary since either of these methods has yarn unwrapping from the outside. End is easy to find.
CONS: More rolling around. More of the yarn will be exposed to dirt.
Perhaps others have their own ideas on the issue?
-
09-08-2012, 06:42 PM #9
I put my skein or rolled up ball in a basket when I'm crocheting..it doesn't get dirt or dust on it that way.
-
09-17-2012, 05:38 AM #10
ANY yarn may tangle during machine winding. You will reach any tangle whether you use yarn from the inside or outside. After you are working, it's just as hard to de-tangle it both ways.
Suggestion:
Cut tiny corner of a "zip" closing plastic baggie
Put yarn into it. Bring yarn end out the cut corner.
Close bag. Yarn feeds thru hole.
Bag keeps yarn clean and helps control rolling about.
Good for center-pull, outer end, or wound-by-hand yarn.Last edited by Dsynr; 09-17-2012 at 05:42 AM.
-
Post Thanks / Like - 0 Thanks, 2 LikesJudi Gums, billieconrad liked this post